Filter
Top Products
P314 Broadband Sharing Gateway with 4-Port Switch
Remote Node Setup 4-5
Field Description Example
Private
This field is valid only for
PPPoE
encapsulation.
This
parameter determines if the Prestige will include the route to this
remote node in its RIP broadcasts. If set to
Yes
, this route is kept
private and not included in RIP broadcast. If
No
, the route to this
remote node will be propagated to other hosts through RIP
broadcasts.
Yes
RIP
Press the [SPACE BAR] to select the
RIP direction
from
Both/
None
/
In Only
/
Out Only
. Please see section 3.1.4 for more
information on RIP. The default for RIP on the WAN side is
None.
It is recommended you do not change this setting.
None
Version
Press the [SPACE BAR] to select the RIP version from
RIP-1/RIP-
2B/RIP-2M
or
None.
Multicast
IGMP (Internet Group Multicast Protocol) is a session-layer
protocol used to establish membership in a Multicast group. The
Prestige supports both IGMP version 1 (
IGMP-v1
) and
IGMP-v2
.
Press [SPACE BAR]
to enable IP Multicasting or select
None
to
disable it. Please see Part 1 for more information on these two
fields.
None
Once you have completed filling in the Network Layer Options Menu, press [ENTER] to return to
Menu 11. Press [ENTER] at the message [Press ENTER to Confirm...] to save your configuration,
or press [ESC] at any time to cancel.
4.3 Remote Node Filter
Move the cursor to the field
Edit Filter Sets
in
Menu 11.1
, then press the
[SPACE BAR]
to toggle and set
the value to
YES
. Press [ENTER] to open
Menu 11.5 – Remote Node Filter
.
Use
Menu 11.5
to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote
node and the Prestige and to prevent certain packets from triggering calls. You can specify up to 4 filter sets
separated by a comma, e.g., 1, 5, 9, 12, in each
filter
field. The default is no filters.
Note that spaces are accepted in this field. For more information on defining the filters, please refer to the
chapter on filters. Note that for
PPPoE encapsulation, you can also specify remote node call filter sets.