USING THE M208’S COMMAND SET: npsh Command Set 119
output I/O port as follows:
THE QUICK BROWN FOX JUMPS OVER THE LAZY DOG 1234567890 DE
THE QUICK BROWN FOX JUMPS OVER THE LAZY DOG 1234567890 DE
THE QUICK BROWN FOX JUMPS OVER THE LAZY DOG 1234567890 DE
THE QUICK BROWN FOX JUMPS OVER THE LAZY DOG 1234567890 DE
...
3 loopback test.
Any input characters from the device attached to the output I/O port are
echoed back as output characters.
See also: stop on page 119 and list test on page 101.
stop
stop all|prn|com1|com2
Stop an output test on the specified I/O port(s).
See also: start on page 118 and list test on page 101.
Store Commands
Change critical parameters such as network, I/O port, and protocol settings.
The three command possibilities are:
store
choice parameters
Store some values.
store
choice
from default Store default settings.
store
choice
from current Store current settings.
choice and parameters can be any of the options listed next.
Once you store any parameters, you need to issue a reset command or do a
cold reboot of the M208 to apply the changes. Otherwise, you will still be
using the current settings.
For the store commands, these new words are important to know:
ifnum Interface number. An index to a Network Interface Tap
(NIT). ifnum will always be 1 for the since there is only one
network interface, Ethernet.
Note
