INSTALLING THE M208 ON THE NETWORK: Overview 15
INSTALLING THE M208 ON THE NETWORK
Overview
The first step of your M208 setup is to attach it to the network. This section tells you
how to do that and also covers the M208’s network interfaces.
Preparing for Installation
Before unpacking and installing the hardware, read the FCC Warning.
Unpacking the M208
Before unpacking the M208, check the package for any obvious damage resulting
from mishandling. If the outside box is damaged, open it and check for any damage to
the contents. Immediately report any damage to the shipping company.
Unpack the M208 and check the contents and serial numbers against the packing slip.
Immediately report any errors or shortages to your vendor. If everything is in accept-
able order, fill out the Warranty Registration/Customer Survey card and mail it in.
FCC Warning
This equipment generates, uses and can radiate radio frequency energy.
If it is not installed and used as directed in this manual, interference to
radio communications may result. The equipment has been tested and
found to comply with the limits for a Class A computing device
pursuant to Subpart B of Part 15 of FCC rules, which are designed to
provide reasonable protection against such interference when operated
in a commercial environment. Operation of this equipment in a
residential area is likely to cause interference. In such a case the user
will be required to correct the interference at the expense of the user.
