Setting Up Your Printer
28 Kodak ESP 7 Printer User Guide
8 After completing your entry, select the DONE key, and then press OK.
The LED will be continuously lit when you are connected to a wireless network. This does
not guarantee you are connected. You must verify that you are connected. See “Verifying
network configuration” on page 30.
Connecting to an unlisted network
1
Wi-Fi Setup Wizard is the first option; press OK to select it.
2 If your network does not appear in the list and is configured to not broadcast its SSID,
select
Unlisted Network and press OK.
3 Follow the prompts to enter the network name using the keyboard visible on the LCD
screen. Press
, , orto select a key. Enter the alphanumeric string accurately,
using the same upper and lower case letters as your SSID. After completing your entry,
select
DONE, and then press OK.
4 Select
WEP or WPA/WPA2 as required for your network's security setup, and then press
OK.
5 Enter the security information required using the LCD screen keyboard.
• Press , , orto select a key. Select <BKSP to erase any incorrect
characters. Then select
DONE and press OK.
Key/Passphrase/
Security String
Description
WEP Key
5 or 13 ASCI characters; case-insensitive
or
10 or a 26 Hexidecimal digits; case-insensitive.
WPA /WPA2 phrase
8-63 printable ASCI; case-sensitive characters.
LED Status Description
Fully Lit When lit, signals that a wireless (Wi-Fi) network
connection has authenticated to the router, but
your connection may not be active. You can
verify the connection through the Network
Settings menu.
Blinking
Blinks when
• searching for an available Wi-Fi network
within range
• existing signal is too weak to transmit
The LED has a repetitive cycle of blinking, then
resting for 15 seconds, followed by blinking
again. The Wi-Fi radio will continue to attempt
connection to the network until a connection is
established.
