Chapter 9
Kodak ESP 7 Printer User Guide 83
Print too light
.
• Make sure the paper is loaded with the print side face down. Reload it if necessary.
• Try taking the picture again with the flash off. Refer to your camera user’s guide for
details.
• Adjust the exposure compensation on your camera and try taking the picture again.
Refer to your camera user’s guide for details.
• Edit the picture on your computer.
Printing slow
• Make sure the printer is not placed in direct sunlight or is not operating in a high-
temperature environment (higher than 95° Fahrenheit or 35° Celsius).
• Close any unnecessary software applications.
• Make sure your computer meets the minimum system requirements. Upgrade your
system if necessary.
Printing stops
Printing stops during mid-print. Paper stops feeding, and status light may blink.
To check the paper:
1 Remove any loose paper from the printer. Check the paper access door in the rear of the
printer.
2 Inspect the paper supplies and reload with new paper if necessary.
3 Carefully “fan” the paper to keep the sheets from sticking together.
4 Reload the paper tray. Do not overload.
5 Press
Start to continue.
Caution: For best results, use Kodak paper and ink cartridges for your Kodak
All-in-One printer.
Note: When printing a large number of prints, printing may slow down to prevent
the printhead from overheating.
Caution: For best results, use Kodak paper and ink cartridges for your Kodak
All-in-One printer.
