NETGEAR 54 Mbps Wireless Access Point WG602v4 Reference Manual
4-4 Advanced Configuration
v1.0, June 2007
3. Verify connectivity across the network.
If you enabled wireless client association on both APs, a computer on either AP should be able
to connect to the Internet or share files and printers of any other PCs or servers connected to
the network.
Configuring Wireless Multi-Point Bridging
In this mode, the WG602v4 will communicate with up to four bridge-mode wireless access points
by entering the MAC address (physical address) of each of the bridge-mode APs in the fields
provided. In addition, if you check the Enable Wireless Client Association checkbox, wireless
clients will also be serviced by this access point. Each wireless access point you enter will be listed
in the Wireless Remote Access Point List.
To configure wireless Multi-point Bridging:
1. Open a web browser and log into the WG602v4 using the addressing scheme you have set up
