Using the transmitter
16
Activating/deactivating the RF signal
To deactivate the RF signal:
To activate the RF signal:
Monitoring the audio signal via headphones
You can monitor the audio signal via the headphone output.
̈ Set the headphone volume control · to the minimum position.
̈ Connect headphones with a ¼” (6.3 mm) stereo jack plug to the headphone output ³.
̈ Gradually increase the volume and monitor the audio signal with the lowest possible
volume.
Synchronizing transmitters and receivers via the infra-red
interface
Easy Setup Sync function (EK 300 IEM G3 -> SR 300 IEM G3)
Once you have performed a frequency preset scan with your EK 300 IEM G3 receiver (see the
instruction manual of the receiver), you can use the Easy Setup Sync function to transfer
unused frequency presets from the receiver to several transmitters via the infra-red
interface. The receiver transfers the first unused channel from the current frequency bank to
the first transmitter and the next unused channel to the second transmitter and so on.
̈ When the standard display is shown on the display panel, briefly press the
STANDBY button.
“RF Mute On?” appears on the display panel.
̈ Press the jog dial.
The RF signal is deactivated. The transmission icon ቦ
is not displayed.
In
addition, the display backlighting changes from orange to red and “RF Mute”
flashes in alternation with the standard display.
̈ Press the STANDBY button.
“RF Mute Off?” appears on the display panel.
̈ Press the jog dial.
The RF signal is activated and the transmission icon ቦ
is displayed.
The display
backlighting changes from red to orange.
You can also deactivate the RF signal on switch-on. For more information, refer to
the chapter “Switching the transmitter on/off” on page 14.
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
̈ Set the headphone volume control · to the minimum position before putting the
headphones on.
̈ Do not continuously expose yourself to high volumes.
³ ·
