Adjusting settings via the operating menu
30
Adjusting the receiver parameters and activating/deactivating their transfer to
the receiver – “Sync Settings”
Via the “Sync Settings” submenu, you can adjust the following parameters for the
EK 300 IEM receiver:
You can specify for each parameter whether it is to be transferred to the receiver during
synchronization.
By pressing the » button on the transmitter, the parameters are transferred from the
transmitter to the receiver (see page 16).
Advanced Menu
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Menu item Transferred receiver parameter
Balance Balance or Focus setting
(“−15”/“+15”)
Squelch Squelch setting
(“5 dB” ... “25 dB”)
Mode Audio mode setting
(“Stereo”/“Focus”)
High boost Treble boost setting for output signal
(“flat”/“High boost” (8 dB at 10 kHz))
Auto Lock Lock mode setting
(“active”/“inactive”)
Limiter Limiter setting
(“−18 dB”, “−12 dB”, “−6dB”, “Off”)
Parameter Transfer is ...
... deactivated
... activated
-60 dB
Sync
PEAK
-10
0
40
30
20
10
-20
-30
-40
AF
RF
-60 dB
Sync
PEAK
-10
0
40
30
20
10
-20
-30
-40
AF
RF
