3Com 2250 Switch User Manual


 
Physical Features 11
Table 5 10BASE-T/100BASE-TX/1000BASE-T Ports
(4) Module Active LEDs
The Module Active LEDs show the status of any SFP
modules that are installed.
(5) Power LED
The Power LED shows the power status of the Switch.
Flashing Packets are being received or transmit-
ted on the port
Off Link not established, either nothing is
connected to the port, or there is a
problem.
Verify that the attached device is
powered on
Verify that the cable or fiber is the
correct type and is not faulty
For fiber connections, ensure that the
receive (RX) and transmit (TX) cable
connectors are not swapped
If these checks do not identify the cause
of the problem, it may be that the unit
or the device connected to the port is
faulty. Contact your 3Com network sup-
plier for further advice.
Status Meaning
Green Link established, operating at 1000
Mbps
Yellow Link established, operating at 10 or 100
Mbps
Flashing Green Packets are being received or transmit-
ted on the port at 1000 Mbps
Flashing Yellow Packets are being received or transmit-
ted on the port at 10 or 100 Mbps
Status Meaning
Flashing Yellow to
Green
Port disabled or link loopback error
Off Link not established, either nothing is
connected to the port, or there is a
problem.
Verify that the attached device is
powered on
Verify that the cable or fiber is the
correct type and is not faulty
For fiber connections, ensure that the
receive (RX) and transmit (TX) cable
connectors are not swapped
If these checks do not identify the cause
of the problem, it may be that the unit
or the device connected to the port is
faulty. Contact your 3Com network sup-
plier for further advice.
Status Meaning
Green Fiber SFP is inserted in the slot
Off No fiber SFP is inserted in the slot
Status Meaning
Green The unit is powered on and ready for use
Status Meaning