Filter
Top Products
10 Quick Installation Guide
Example:
In-band port-based
interface
As an alternative to a VLAN-based management interface, you can define
a port-based router management interface for in-band management:
If you use this type of management interface, all VLANs are removed, a
default VLAN is created, and the VLAN mode changes to allClosed.
To define a port-based interface:
1
Define an IP interface. From the top level of the Administration Console,
enter:
ip interface define
The system prompts you for the interface parameters. To accept the
current value shown in brackets at any prompt, press Return.
2
Enter the IP address of the management interface.
3
Enter the subnet mask of the management interface.
4
Enter
port
5
The system informs you what will happen to the current VLAN
configuration if you choose to continue with
yes
6
Enter the bridge port number.
Example:
These management access mechanisms are described more completely in
the “Quick Setup for Management Access” chapter in the Getting
Starting Guide and the “Management Access” chapter in the
Implementation Guide.
Select menu option: ip interface define
Enter IP address: 158.101.134.62
Enter subnet mask [255.255.255.0]:
Enter interface type (vlan,port) [vlan]: vlan
Enter VLAN interface index {1-12,15|?}: 1
Select menu option: ip interface define
Enter IP address: 158.101.134.62
Enter subnet mask [255.255.255.0]:
Enter interface type (vlan,port) [vlan]: port
VLAN mode must be changed to allClosed to support this interface.
This will remove all VLANs, then re-create the
Default VLAN - continue? (n,y) [y]: y
Select bridge port {1-12,15|?}: 1