3Com 3500 Network Router User Manual


 
6 Quick Installation Guide
To get your system powered up and ready to operate:
1
Verify that each unused slot is covered with a blank faceplate.
To view possible error messages while the system is running power-up
diagnostics, connect a terminal, workstation, or PC with terminal
emulation software to the system’s terminal serial port. See the next
section and Table 5.
2
On the back panel, insert the power cord into the power receptacle. See .
CAUTION: To prevent a possible fire hazard, verify that the power cord is
fully inserted.
If the spring-loaded power supply latch partially covers the power
receptacle, it is because the power supply is not fully inserted and the
locking pin cannot fully extend into its slot.
Figure 1
System Power Receptacle
3
Insert the other end of the power cable into a power outlet.
4
Repeat steps 2 and 3 for the second power supply if you have one.
Power Up
the System
8
Power Supply No. 2
DC OK
!
DC OK
!
Power Supply No. 1
Power Supply latch