Filter
Top Products
36 CHAPTER 5: ROUTER CONFIGURATION
Status Figure 20 Status Screen
There are two buttons on this screen - Connect and Disconnect. These
buttons allow you to manually connect or disconnect your router from
your ISP’s service.
LAN Setup Your Router is equipped with a DHCP server that will automatically assign
IP addresses to each computer on your network. The factory default
settings for the DHCP server will work in most any application. If you
need to make changes to the settings, you can do so.
The changes that you can make are:
■ Change the Internal IP address of the Router. The default =
192.168.1.1
■ Change the Subnet Mask. The default = 255.255.255.0
■ Enable/Disable the DHCP Server Function. Default = ON (Enabled)
■ Specify the Starting and Ending IP Pool Address. Default = Starting: 2 /
Ending: 254
■ Specify the IP address Lease Time. Default = Half day
■ Specify a local Domain Name. Default = NONE
■ To make changes, click "LAN Settings" on the LAN tab to the left.