Filter
Top Products
Introduction 1 - 5
Configure the switches to the settings you want if different than the
default values. (Refer to Table 1-2, Table 1-3, Table 1-4, and Table 1-5 for an
explanation of the dip switch settings.) Figure 1-2 shows the location of the
dip switches.
Figure 1-2. 10BASE-T Module and Dip Switch Locations
Dip Switch SW1 (Port Status)
The eight switches on dip switch SW1 allow you to enable or disable each
of the eight ports. The switches are labeled 1 through 8 and correspond to
the respective eight ports. The Off position disables the port and the On
position enables the port. The switch settings are initially configured in the