Filter
Top Products
3 - 2 ONline Ethernet 10BASE-T Module User’s Guide
Unpacking Procedures
Use the following procedure when unpacking your 10BASE-T Module.
1. Verify that the 10BASE-T Module is the correct model by matching
the model number listed on the side of the shipping carton to the
model number you ordered (5108M-TP).
Note that the product model number printed on the shipping box
differs from the model number on the product. The model number
on the shipping box contains the prefix ’3C9’.
2. Remove the 10BASE-T Module from the shipping carton.
3. Remove the module from the anti-static shielding bag and inspect it
for damage. Always handle the 10BASE-T Module by the faceplate
being careful not to touch the components.
If the module appears to be damaged, replace it in the anti-static
shielding bag, return it to the shipping carton, and contact your local
supplier.
3Com suggests you keep the shipping carton and anti-static shielding bag
in which your module was shipped in case you later want to repackage the
module for storage or shipment.
We also suggest that you record the serial number of your 10BASE-T
Module. We have provided a log for this and other information specific to
your modules under the Slot Usage Chart in Appendix B of the ONline
System Concentrator Installation and Operation Guide.
Installation Procedures
You do not need to power down the ONline System Concentrator to install
the 10BASE-T Module. You can insert the module while the concentrator is
operating (called a hot insertion). Follow the steps below to install the
10BASE-T Module.