Filter
Top Products
7-8 CHAPTER 7: ADMINISTERING IP ROUTING
Removing a Route To remove a route:
1 From the top level of the Administration Console, enter:
ip route remove
2 Enter the slot of the switching module for which you want to remove a
static route.
3 Enter the destination IP address of the route.
4 Enter the subnet mask of the route.
The route is immediately deleted from the routing table.
Flushing a Route Flushing deletes all learned routes from the routing table.
To flush all learned routes:
1 From the top level of the Administration Console, enter:
ip route flush
2 Enter the slot of the switching module for which you want to delete the
learned routes.
All learned routes are immediately deleted from the routing table.
Setting the Default
Route
The default route is used by the switching module to forward packets that
do not match any other routing table entry. A switching module can learn a
default route using RIP, or you can configure a default route statically.
To statically configure the default route:
1 From the top level of the Administration Console, enter:
ip route default
2 Enter the slot of the switching module for which you want to set a default
route. Enter the gateway IP address of the route.
The default route is immediately added to the routing table.
Top-Level Menu
system
ethernet
fddi
tokenring
bridge
➧ip
ipx
appletalk
snmp
analyzer
script
logout
interface
➧route
arp
udpHelper
forwarding
rip
ping
statistics
display
static
➧remove
flush
default
noDefault
Top-Level Menu
system
ethernet
fddi
tokenring
bridge
➧ip
ipx
appletalk
snmp
analyzer
script
logout
interface
➧route
arp
udpHelper
forwarding
rip
ping
statistics
display
static
remove
➧flush
default
noDefault
Top-Level Menu
system
ethernet
fddi
tokenring
bridge
➧ip
ipx
appletalk
snmp
analyzer
script
logout
interface
➧route
arp
udpHelper
forwarding
rip
ping
statistics
display
static
remove
flush
➧default
noDefault