Filter
Top Products
Administering Interfaces 8-3
Displaying IPX
Interfaces
You can display a table that shows all IPX interfaces and their parameter
settings configured for each EFSM in the system.
To display IPX interface information:
1 From the Administration Console top-level menu, enter:
ipx interface display
2 Enter the slot(s) of the EFSM(s) for which you want to display the
interface information. Separate non-consecutive slots with commas (,).
Enter a consecutive series of slots using a dash (-).
As shown in the following example, the current configuration is
displayed. It contains IPX forwarding and RIP and SAP information for
that slot as well as IPX interface information.
Defining an
Interface
When you define an interface, you define the interface’s IPX address,
cost, format, and the EFSM ports associated with the interface.
To define an IPX interface:
1 From the Administration Console top-level menu, enter:
ipx interface define
2 Enter the slot of the EFSM for which you want to define an interface.
You are prompted for the interface’s parameters. To use the value in
brackets, press [Return] at the prompt.
3 Enter the IPX network address of the interface.
4 Enter the cost of the interface.
5 Enter the format of the interface.
Top-Level Menu
system
ethernet
fddi
tokenring
bridge
ip
➧ipx
appletalk
snmp
analyzer
script
logout
➧interface
route
server
forwarding
rip
enhanced
sap
statistics
➧display
define
modify
remove
o
t 3 - IPX forwarding is enabled, RIP is active, SAP is active
Index IPX Address Cost Format Ports (1-2=FDDI, 3-18=Ethernet)
1 45469f30 1 802.2 3-10
2 5d41a110 1 802.2 11-18
Top-Level Menu
system
ethernet
fddi
tokenring
bridge
ip
➧ipx
appletalk
snmp
analyzer
script
logout
➧interface
route
server
forwarding
rip
enhanced
sap
statistics
display
➧define
modify
remove