Filter
Top Products
8-4 CHAPTER 8: ADMINISTERING IPX ROUTING
6 Enter the port(s) that you want to include in the interface. Separate
non-consecutive ports with commas (,). Enter a consecutive series of
ports using a dash (-).
See the example below:
Modifying an
Interface
You may want to change the configuration of an interface you have
already defined.
To modify an IPX interface:
1 From the Administration Console top-level menu, enter:
ipx interface modify
2 Enter the slot of the EFSM for which you want to modify an interface.
You are prompted for the interface parameters. Press [Return] at the
prompts for which you do not want to modify the value.
3 Modify the existing interface parameters by entering a new value at the
prompt.
Removing an
Interface
You may want to remove an interface if you no longer perform routing
on the ports associated with the interface.
To remove an IPX interface definition:
1 From the Administration Console top-level menu, enter:
ipx interface remove
2 Enter the slot of the EFSM from which you want to remove an interface.
3 Enter the index number(s) of the interface(s) you want to remove.
Select slot {3-4} [3-4]: 3
Enter IPX Address: 0x45469f30
Enter Cost: 1
Enter Frame Format (Ethernet II: 0, 802.2: 1, Raw 802.3: 2, SNAP: 3): 1
Enter ports(s) (1-2=FDDI, 3-18=Ethernet) (1-18|all): 3-10,13,16
Top-Level Menu
system
ethernet
fddi
tokenring
bridge
ip
➧ipx
appletalk
snmp
analyzer
script
logout
➧interface
route
server
forwarding
rip
enhanced
sap
statistics
display
define
➧modify
remove
Top-Level Menu
system
ethernet
fddi
tokenring
bridge
ip
➧ipx
appletalk
snmp
analyzer
script
logout
➧interface
route
server
forwarding
rip
enhanced
sap
statistics
display
define
modify
➧remove