Filter
Top Products
V6000 Analog Integrated Branch Office Solution Installation Guide V6000 Analog Integrated Branch Office Sol
24
Configuring the Internal Routing Table
To configure internal routing, follow these 4 steps:
1 In the ‘Quick Setup’ screen, click the button Æ adjacent to the label ‘Tel to IP Routing
Table’; the ‘Tel to IP Routing Table’ screen opens (see
Figure 6).
Figure 5 Tel to IP Routing Table
2 In row 1, under column ‘Dest. Phone Prefix’ enter 10, under column ‘Source Phone
Prefix’ enter * (wildcard) and under column ‘Dest. IP Address’ enter the IP address you
assigned the V6000; every call that its destination number starts with 10 is routed to the
V6000.
3 Repeat Step 2 for the second row, but this time enter 20 under column ‘Dest. Phone
Prefix’; every call that its destination number starts with 20 is routed to the V6000.
4 Click the Submit button and then click Quick Setup; you’re returned to the ‘Quick Setup’
screen.
Making Calls
Making an FXS to FXS Call
The following setup requires two telephones (A and B) and two RJ-11 cables, using the
settings from the example shown in
Figure 5.
To make an FXS to FXS call, follow these 3 steps:
1 Connect the RJ-11 cable of telephone A to port 1 of module 1 (where module 1 is an
FXS module). Connect the RJ-11 cable of telephone B to port 2 in the same module
(Module 1).
2 Offhook the receiver of telephone A (whose number you defined as 101) and dial 102
(the automatically defined number of port 2); telephone B connected to port 2 rings.
3 Offhook telephone B and test the line for voice.