Filter
Top Products
Advanced 71
■ Gateway — the router used to route data to the network specified by
the network address.
To add a static route entry to the table, click Add and on the screen that
appears type in the network address, subnet mask and router. To change
an entry, click Edit and to delete an entry, click Delete. After you have
finished making changes to the table, click Apply.
RIP Parameters
Figure 59 RIP Parameter Screen
You can set up RIP independently on both LAN and WAN interfaces.
1 Select the RIP Mode Enable option.
2 Select the appropriate option to enable or disable Auto Summary. Auto
Summarization sends simplified routing data to other RIP-enabled devices
rather than full routing data.
3 Select the Operation Mode:
■ Disabled — RIP is not enabled for the WAN or LAN interface.
■ Enabled — RIP is enabled for the WAN or LAN interface. The router
will transmit RIP update information to other RIP-enabled devices.
■ Silent — RIP is enabled, however the router only receives RIP update
messages, it will not transmit any messages itself.
4 In the Version field, select RIPv1 or RIPv2.