Filter
Top Products
11
3M
™
Pocket Projector MP180
© 2011 3M. All Rights Reserved.
English
Installing and Charging the Projector Battery
Removing the Protective Film
When the projector is shipped, there is a protective film between the battery and
the battery contacts on the projector. Remove the protective film by removing the
battery and the protective film, discard the film and finally install the battery.
Install Battery
The 3M projector comes with a rechargeable battery. The battery should be fully
charged before using the projector with the battery.
To install the battery, orient the contacts on the battery toward the contacts on the
projector, insert the end farthest from the battery latch first, then push down until
the battery clicks into place. The projector will automatically turn on.
Remove Battery
To remove the battery, slide the battery latch away from the battery and then lift the
battery out, starting at the end closest to the latch.
Important Note: Use only the 3M-specified battery: 78-6972-0026-5.
Note: The projector will turn on automatically when the battery is installed.