3M MP8650 Projector User Manual


 
20
3M 1997
3M Multimedia Projector MP8650
Section 9: Technical Specifications
9-1. Specifications
Width 28.1 cm (10.95 inch)
Height 35.6 cm (13.88 inch)
Depth 48.6 cm (18.95 inch)
Weight 14 kg (30.94 lbs)
Panel size 8.1 cm (3.2 inches)
Number of pixels per panel 480,000 pixels (H800 X V600), 3 panels = 1.44 million total pixels
Dot defect < 0.011% of total pixel count
Zoom lens 1.6:1
Metal halide lamp 350W, rated at 1000 hours to half brightness
(110V–user can replace lamp, 220V–lamp must be replaced at service center)
Power supply AC90-132V, 50/60Hz
AC170-260V, 50/60Hz
Power consumption Maximum 470W (typical)
Storage temperature range –20°C to 60°C (–4°F to 140°F)
Operating temperature range 0°C to 35°C (32°F to 95°F)
Input terminals S-Video: Mini DIN4-pin terminal
Video: RCA jack
Audio: RCA jack
Computer (RGB): D sub15-pin HD terminal
Input signals S-Video: Luminance 1.0V peak-to-peak , 75 termination
Chroma 0.286V peak-to-peak (burst signal) 75 term.
Video: 1.0V peak-to-peak, 75 termination
Audio: 260mvRMS, across 46k
Computer (RGB1/RGB2): 0~0.7V peak-to-peak, 75
RGB (computer) input Audio: RCA jack
Output terminals Computer (RGB): D sub15-pin HD terminal
Audio: RCA jack
Output signals Monitor: 0~0.7V peak-to-peak, 75
Audio: 7V peak-to-peak or less, 680 termination
Batteries for remote control Three AAA, 1.5 Volt
9-2. S-Video Input Signal Terminal
The following illustration (Figure 9-1) identifies the terminal connections for the Mini DIN4-pin.
Luminance
Signal
Chrominance
Signal
Ground
Ground
Figure 9-1. S-Video Input (Mini DIN4-pin)
Video input signal terminals are detected by the MP8650 in the following order of priority:
D S-video input terminal
D RCA jack input terminal