Filter
Top Products
Command Line Interface
4-56
Command Usage
• The system prompts for data required to complete the copy command.
• The destination file name should not contain slashes (\ or /), the leading letter of
the file name should not be a period (.), and the maximum length for file names
on the TFTP server is 127 characters or 31 characters for files on the switch.
(Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
• Due to the size limit of the flash memory, the switch supports only two operation
code files.
• The maximum number of user-defined configuration files depends on available
memory.
• You can use “Factory_Default_Config.cfg” as the source to copy from the
factory default configuration file, but you cannot use it as the destination.
• To replace the startup configuration, you must use startup-config as the
destination.
• The Boot ROM and Loader cannot be uploaded or downloaded from the TFTP
server. You must use a direct console connection and access the download
menu during a boot up to download the Boot ROM (or diagnostic) image.
Example
The following example shows how to upload the configuration settings to a file on
the TFTP server:
The following example shows how to copy the running configuration to a startup file.
Console#copy file tftp
Choose file type:
1. config: 2. opcode: <1-2>: 1
Source file name: startup
TFTP server ip address: 10.1.0.99
Destination file name: startup.01
TFTP completed.
Success.
Console#
Console#copy running-config file
destination file name: startup
Write to FLASH Programming.
\Write to FLASH finish.
Success.
Console#