Filter
Top Products
Command Line Interface
4-166
show ip igmp snooping mrouter
This command displays information on statically configured and dynamically learned
multicast router ports.
Syntax
show ip igmp snooping mrouter [vlan vlan-id]
vlan-id - VLAN ID (Range: 1-4093)
Default Setting
Displays multicast router ports for all configured VLANs.
Command Mode
Privileged Exec
Command Usage
Multicast router port types displayed include Static or Dynamic.
Example
The following shows that port 11 in VLAN 1 is attached to a multicast router:
IP Interface Commands
There are no IP addresses assigned to this switch by default. You must manually
configure a new address to manage the switch over your network or to connect the
switch to existing IP subnets. You may also need to a establish a default gateway
between this device and management stations or other devices that exist on another
network segment.
Basic IP Configuration
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Ports Type
---- ------------------- -------
1 Eth 1/11 Static
2 Eth 1/12 Dynamic
Console#
Command Function Mod
e
Pag
e
ip address Sets the IP address for the current interface IC 4-167
ip default-gateway Defines the default gateway through which this switch can reach
other subnetworks
GC 4-168
show ip interface Displays the IP settings for this device PE 4-168
show ip redirects Displays the default gateway configured for this device PE 4-169
ping Sends ICMP echo request packets to another node on the
network
NE,
PE
4-169