Filter
Top Products
105
Installing the system into the rack
To install the system into the rack:
1 Remove the front bezel from the server. Refer to “Removing the
front bezel” on page 33 for instructions.
2 Remove the top panel of the server.
(1) Use a screw driver to remove the two rear screws holding the
top panel to the chassis.
(2) Slide the top panel backward to detach it from the chassis.
3 Remove the rubber foot stands from the server.
(1) Lay the server on its side on a flat, stable surface.
(2) Use the flat side of a screw driver to remove the plug from
the foot stands. Keep these plugs for later use.
AA G701 - EN.book Page 105 Tuesday, February 25, 2003 5:19 PM