Filter
Top Products
33
Opening the server
Caution! Before you proceed, make sure that you have turned
off your system and all peripherals connected to it. Read the
“Preinstallation instructions” on page 31.
You need to open the server before you can install additional
components. The front bezel and left side panel are removable to
allow access to the system’s internal components. Refer to the
following sections for instructions.
Note: The illustrations used in this section shows the Altos G701
server chassis.
Opening the front bezel
A security lock secures the front bezel to protect your system unit
against unauthorized access.
To open the front bezel:
1 Insert the key into the lock and turn it clockwise until it points to
the unlock icon .
2 Pull open the front bezel.
Removing the front bezel
The front bezel is attached to the chassis by screwless hinges.
To remove the front bezel:
1 Unlock the door with the key (when necessary).
2 Open it to more than a 45° angle.
3 Lift it up a little (1), then move it away from the chassis (2).
AA G701 - EN.book Page 33 Tuesday, February 25, 2003 5:19 PM