Filter
Top Products
3 Upgrading the system
40
Installing the hot-swappable cage
1 Detach the chassis panels and remove the air baffle.
2 Connect the following cables to the SCSI backplane board:
aSCSI cable
b SCSI drive power cable
c SCSI drive fault LED cable
3 Attach the other end of these cables to the corresponding
connectors on the mainboard.
Refer to “Mainboard layout” on page 10 for the location of the
connectors.
4 Insert the hot-swappable cage into the housing (2), then tighten
the four thumbscrews to secure it to the chassis (1).
5 Reinstall the air baffle and the chassis panels.
AA G701 - EN.book Page 40 Tuesday, February 25, 2003 5:19 PM