Filter
Top Products
PC 6170 User’s
Manual
BUTTON-ONLY
Follows the conventional way of
turning
OFF
system
power (via power
button).
Upon
selecting this option, the
K
B POWER ON
Password line appears. Press <E
nter> and you’ll be
Password
Hot KEY
prompted to
enter
and confi
rm
a
password of your
choi
ce.
After setting the password, succeeding
attempts to
power ON the
system
will result to null.
For system to
acti
vate, user must
input
the password
via
keyboard
then press <Enter>.
This option i
s very similar
with that of
P
assword.
Hot-key combi
nations
range
from
Ctrl
-F1 to Ctrl
-F12.
User m
ay define this
combination
from the
Hot key
Power ON opti
on.
Onboard FDC Controller
Select Enabled if your system has a
floppy disk
controller (FDC) installed
on the system
board and
you
wish to use it. If
you
install
and-in
FDC or
the system
has no floppy
drive, select Disabled
in
this field.
The options
available
are Enabled, Disabled.
Onboard
Serial
Port 1/Port 2
Select
an address
and corresponding interrupt for the first and second
serial ports. The options available
are 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4,
2F8/IRQ3, Disabled, Auto.
UART2 Duplex
Mode
The second serial port offers
these infrared interface modes:
9
IrDA
9
ASKIR
IrDA-compliant
serial infrared port
9
Normal (default
value)
NOTE:
The UART Mode Select
will
not appear on
the menu
once you disable
the
setting of Onboard Serial Port 2.
When UART
Mode Select is set as
ASKIR or IrDA, the options
RxD, TxD
Active and IR
Transmittion
delay
will appear.
Parallel Port Mode
Select
an operating mode for
the onboard
parallel (printer) port. Select
Normal
unless
your
hardware
and
software
require
one
of
the
other
modes
offered
in this field. The options available
are
EPP1.9, ECP, SPP,
ECPEPP1.7, and EPP1.7.
50
SBC83810 BIOS Setup