Filter
Top Products
14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
PCH 5120
12.1” industrial Panel PC
IP67 rated fully enclosure
Step 3: Replace the cover and fasten the screws.
Step 4: Make sure the outer seal is seated properly, then replace the cover.
3.4 JUMPER SETTINGS
NOTE:
A jumper is a metal bridge that is used to close an electrical circuit. It
consists of two metal pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect them. To CLOSE/
SHORT a jumper means connecting the pins of the jumper with the
plastic clip and to OPEN a jumper means removing the plastic clip from a
jumper.
3.4.1 RESET CMOS
Jumper Label: JP11
Jumper Type: 3-pin header
Jumper Settings: See Table 3-1
This jumper will reset the CMOS. Turn off the system. Set the jumper to "Reset CMOS", turn on the power
for a few seconds. Turn off the system. Set the jumper back to "Normal".
3.4.2 AT/ATX POWER
Jumper Label: JP10
Jumper Type: 2-pin header
Jumper Settings: See Table 3-2