Adaptec 48300 Computer Drive User Manual


 
Chapter 5: Installing the HostRAID Controller and Disk Drives 24
Before You Begin
Read the Safety Information on page 77.
Familiarize yourself with your HostRAID controller’s physical features and the RAID levels
that it supports (see page 12).
Ensure that you have the right quantity of disk drives for the RAID level you want to use
for your arrays (see page 58).
Ensure that you have the proper cables for your controller and disk drives (see page 12).
If you have a low-profile computer cabinet, replace the original full-height bracket with the
low-profile bracket supplied in the controller kit.
Caution:
Handle the controller by its bracket or edges only.
Installing the HostRAID Controller
This section describes how to install your HostRAID controller into your computer cabinet.
1 Turn off your computer and disconnect the power cord. Open the cabinet, following the
manufacturer’s instructions.
2 Select an available PCI or PCI-X expansion slot and remove
the slot cover, as shown at right. (see page 12.)
For the best performance, use the available 64-bit slot that’s
compatible with your HostRAID controller.
Caution:
Touch a grounded metal object before
handling the HostRAID controller.
3
As shown at right, insert the HostRAID controller into the
PCI or PCI-X expansion slot and press down gently but
firmly until it clicks into place. When installed properly, the
HostRAID controller should appear level with the
expansion slot.
4 Secure the bracket in the PCI slot, using the retention
device (for instance, a screw or lever) supplied with your
computer.
5 Connect your computer’s disk activity LED cable to the
LED connector on the controller (see page 12).
Ensure that the positive lead of the LED cable (usually a red
wire or a wire marked with a red stripe) is attached to pin 1.
6 Optional—Connect your HostRAID controller’s I2C
connector (not available on all models) to an I2C
connector on an internal backplane or enclosure, using an
I2C cable.
7 Install your disk drives, following the instructions on page 25.
!
!