Filter
Top Products
ADCP-80-524 • Issue 1 • November 2001
Page 31
© 2001, ADC Telecommunications, Inc.
7.2 Cleaning
If excessive dirt is found during the inspection, brush or wipe dust and dirt from the fuse panel
with a soft bristle brush or soft cloth. Care should be taken not to damage the fuses or any
wiring.
7.3 Adjustments
No adjustments in the field are indicated or required. If a circuit is not operating properly,
contact ADC Customer Assistance (see Section 8, Customer Information and Assistance).
7.4 LED Replacement
The power-on and fuse alarm LEDs may be replaced as follows:
1. Pull LED out slowly from the front of the fuse panel.
2. Disconnect both tabs on the LED from the mating terminals (quick-connects or fastons) on
the wires.
3. On the replacement LED, connect the tin tab to the mating terminal on the red wire, and
connect the brass tab to the mating terminal on the black wire.
4. Push the LED back into the panel.