Filter
Top Products
AdderView Installation and Use Page 18
3. Using the AdderView
This section explains the general operation of the AdderView. We recommend that
you read this section before starting to use the product.
3.1 Power on status
At power on the AdderView selects PC number 1 and displays '1'. If a password has
been set then ‘P’ will be displayed and the AdderView will remain locked until a valid
password is entered.
If there is insufficient power available from the connected computers then the
AdderView will indicate the power status as shown in the diagram below. Sufficient
power will normally be available if the cables between the AdderView and PCs are 3
metres or less.