Filter
Top Products
AdderView Installation and Use Page 31
4.8 Cascade query code
The AdderViews use a special ‘query code’ to detect whether or not they are
connected to another AdderView. By default your AdderView uses query code AD.
SmartView (another range of keyboard / mouse / video switches from Adder
Technology) units with firmware versions less than 1.09 used query code EF. This
was found to conflict with a small number of other (rare) devices that used the same
query code so an alternative query code was provided to ensure compatibility. Either
query code may be used but you should make sure that all cascaded AdderView
and SmartView units are set to use the same query code. If any of the cascaded
SmartViews have firmware versions less than 1.09 then the cascade query code for
all the AdderViews and SmartViews should be set to EF.
L7 – Cascade query code = AD (default)
L8 – Cascade query code = EF
4.9 Exit configure mode
When you have finished configuring any special options, simply type ‘E’ followed by
(return) to exit configure mode and return to normal operation mode. The attached
computers can now be switched on.