Filter
Top Products
Addlogix Wireless PC2TV InternetVue 2100 Version 0.2
26
Can the Internet be accessed while projecting through the Wireless PC2TV InternetVue
2100?
The Internet can be accessed either through the computer, the Wireless PC2TV InternetVue
2100, or a wireless access point (if one already exists while being projected onto the display).
If the Internet is accessed via the Wireless PC2TV InternetVue 2100, it is advised that the
Ethernet cable be connected to the Wireless PC2TV InternetVue 2100 before it is powered
up.
Note the following special cases:
The Ethernet port on the board can have DHCP enabled or STATIC addresses. This can be
accomplished from within the Wireless PC2TV InternetVue 2100 application.
Port 80 should be open on the LAN to allow access to the Internet.
Port 21 should be open on the LAN to allow Wireless PC2TV InternetVue 2100 firmware
updates.
The DHCP allocation range is 10.0.0.2 through 10.0.0.254 (IP/subnet of Wireless PC2TV
InternetVue 2100 Ethernet port should be different than 10.0.0.x).
The Wireless PC2TV InternetVue 2100 Ethernet port has a ‘dummy’ MAC address by
default. During the manufacturing process, each device is programmed with a unique MAC
address. This is necessary to avoid MAC address conflict and improper operation of the
device. Note that with a dummy MAC address, there may be some computers which may not
be able to connect to the device
.
How are firmware and applications updated?
To check for firmware/application updates:
1. Power on the Wireless PC2TV InternetVue 2100 and make sure it has an active Internet
connection and FTP port open.
2. Start the Wireless PC2TV InternetVue 2100 application and select the Settings option.
3. Select Firmware update
.
The application checks if a newer firmware version is available for download. If a new
version is available, the Wireless PC2TV InternetVue 2100 application prompts you for
download permission and starts downloading.
After the firmware update is complete, the Wireless PC2TV InternetVue 2100 must be power
cycled.
The Wireless PC2TV InternetVue 2100 reboots on the new firmware, but the Wireless
PC2TV InternetVue 2100 application on the computer must still be updated. This can be
done by uninstalling the old version and executing the "auto-install' procedure.
Why is the SSID different when the firmware is upgraded?
On an upgrade of firmware, the SSID is changed back to its original default. This is done to
simplify the software for the upgrade process.
Does Power-Save mode interfere with Wireless PC2TV InternetVue 2100 operations?
Most laptops have a power management feature (power-save mode) that allows the
management of power to its subsystems when the laptop is running on battery power.