Filter
Top Products
4 Introduction
DLT Drives
Your ADIC FastStor is equipped with a third-, or fourth-generation DLT drive. The DLT4000 and DLT7000 drives can read and
write 2.6 GB, 6.0 GB, and 10.0 GB tape formats for 100% interchange compatibility with earlier DLT drives. The DLT 8000 drive
can read and write 10.0, 15.0, 20.0, and 35.0 GB tape formats for 100% interchange compatibility with the DLT 2000, DLT
2000xt, DLT 4000, and DLT 7000 drives. DLT 8000 default tape density is 40 GB (80 GB compressed) when using the DLTtape
IV data cartridge. Tape density is selectable by the application software or via the Operator Panel..
Model Drive
Model
Cartridge Max Capacity
(density - compressed mode)
Max Capacity
(compressed mode)
Sustained Transfer Rate
(compressed mode)
FastStor DLT4000
DLT4000 20 GB (DLTtape III)
30 GB (DLTtape IIIXT)
40 GB (DLTtape IV)
140 GB
210 GB
280 GB
3.0 MB/sec (180 MB/min)
FastStor DLT7000
DLT7000 20 GB (DLTtape III)
30 GB (DLTtape IIIXT)
70 GB (DLTtape IV)
140 GB
210 GB
490 GB
10.0 MB/sec (600 MB/min)
FastStor DLT8000
DLT8000 20 GB (DLTtape III)
30 GB (DLTtape IIIXT)
80 GB (DLTtape IV)
140 GB
210 GB
560 GB
12.0 MB/sec (720 MB/min)
Maximum Capacity and Sustained Transfer Rates
Options
SCSI Interface
The FastStor is equipped with a Quantum manufactured drive and a corresponding robotics interface. The drive and robotics may
have Single-Ended (SE), Low Voltage Differential/Single-Ended (LVD/SE), or High Voltage Differential (HVD) SCSI interface.
Caution
SE and LVD/SE SCSI devices are not compatible with HVD SCSI devices.
Equipment damage may occur if you connect your FastStor to an
incompatible SCSI bus.