Filter
Top Products
48 Troubleshooting and Diagnostics
FastStor Error Messages
If, during operation of your FastStor an error occurs, the FastStor will halt the current operation and an error message will be
displayed on the LCD. In all cases, after removing the cause of the problem, cycle power on your FastStor and try the last operation
again.
Error Message Listing
A description of each of the FastStor error messages is provided in the following table:
Error Name Description Error Name Description
SERIAL RCV
Interprocessor communication error
PCKR EMPTY *
The media picker was empty
SRC EMPTY *
The source location is empty
SLOT FULL *
There was medium in slot
dEST FULL *
The destination location is full
NVM SELECT
NVRAM selection failure
CPU RX ERR
The motion CPU is not ready to receive
NVM WRITE
NVRAM write failure
CPU TX ERR
The motion CPU is not ready to transmit
dRIVE EJCT
Drive failed to eject medium
SLOT EMPTY
No slot beam was detected
dRIVE LOAd
Unable to load medium into drive
PWR SWITCH
The front power switch was pressed
dRIVE UNLd *
Drive not logically unloaded
HALT
The motion CPU has been halted by a low ACT line
dRIVE HNdL
Drive ‘Operate Handle’ timeout
CAM LIMIT
A cam limit has been reached w/o tripping a sensor
dRIVE BUSY
Drive busy, cannot unload tape
JAW SENSOR
A jaw sensor was tripped
dRIVE PGRM
Attempt to set drive parameters failed
INV MOV OP *
An invalid move operation occurred
dRIVE dOOR
Drive door stepper motor limit
REAR TAPE
A rear tape sensor was not tripped
dRIVE FULL *
The drive was full
FRONT TAPE
A front tape sensor was not tripped
CT FAILED
Cleaning tape failed to clean drive
REAR SLOT
A rear slot sensor was not tripped
dRIVE POST
Drive failed its POST
FRONT SLOT
A front slot sensor was not tripped
RObOT POST
Robotics failed its POST
PCKR FULL *
The media picker was full
* These errors will not appear on the LCD if the error occurred during SCSI interaction.
Note
During the FastStor POST, if the CT FAILEd, dRIVE bUSY, dRIVE dOOR, dRIVE EJCT, dRIVE HNdL, dRIVE LOAd, dRIVE PGRM, or
dRIVE UNLd error occurs, dRIVE POST will appear on the Operators Panel LCD. All other errors occurring during FastStor POST
will result in RObOT POST being displayed.