Filter
Top Products
Chapter 5. Using the Terminal Menu
5-48
ATLAS
_ 800
PLUS
User Manual 61200226L1-1
Quad T1/PRI Module (User Termination/RBS)
When you are working in the User Termination section of the Dial Plan menu, the
Slot is defined as a T1/PRI module, and Sig is set to RBS, the following configura-
tion options are available:
First DS0/Number of DS0s
Write security: 3; Read security: 5
Defines to ATLAS the DS0s which will be used for this end point. These are the
DS0s which will be used by ATLAS to send and receive calls to and from User
equipment (PBX). The incoming calls which will be accepted and the outgoing
calls which will be restricted over these DS0s are set by the Incoming Call Accept
and Outgoing Call Reject Numbers discussed earlier.
DS0s Available
Read security: 5
Indicates which DS0s of the T1 have been defined in this switched end point
(indicated by “
!
“), in another switched end point (indicated by “s”), or in a Dedi-
cated Map (indicated by “n”).
Signaling Method
Write security: 3; Read security: 5
Defines to ATLAS the type of signaling to be used across this trunk. The signaling
selected needs to match that being used by the user equipment (PBX).
The choices are:
• E&M Immediate
•E&M Wink
•Loop Start
• Ground Start
ATLAS converts signaling types between Network and User Terminations.
digits 0—9
This DS0 is available. The digit that displays in this field
represents the last digit of the DS0 number.
*
This port is requesting this DS0 for this connection, but the
DS0 is not yet activated.
!
This DS0 is used by this endpoint.
s
This DS0 is used elsewhere in the switched dialplan.
S
This DS0 is in the switched dialplan and conflicts with this
endpoint.
n
This DS0 is used in one or more dedicated maps.
N
This DS0 is in one or more dedicated maps and conflicts with
this endpoint.