Filter
Top Products
Chapter 5. Using the Terminal Menu
61200226L1-1 ATLAS_ 800
PLUS
User Manual
5-37
Slot/Port (Select list of option modules/ports)
Write security: 3; Read security: 5
These fields are used to select the ATLAS port that terminates a User connec-
tion.
There may be more than one “end point” associated with a particular port. If a
T1 port is connected to a channel bank with analog voice cards, each DS0 or a
group of DS0s may have a different phone number. These would constitute mul-
tiple “end points” over a single physical port.
Signaling: (User Selection - RBS; PRI)
Write security: 3; Read security: 5
Defines the type of signaling being used for this connection (end point). RBS
would be for a T1 using Robbed Bit Signaling while PRI designates a Primary
Rate ISDN interface. This selection is only necessary if a T1/PRI is selected as
the Slot/Port type.
In#Accept
Write security: 3; Read security: 5
This submenu defines the parameters for incoming calls that ATLAS_ 800
PLUS
will accept from the Network.
Source ID
Write Security: 3 Read Security: 5
This field identifies the ID of the call sources that this endpoint will
accept calls from. The Source ID field is used to simplify the creation
of a Dial Plan in applications where the criteria for switching calls to
a certain endpoint is a function of which endpoint originated the call.
Source ID may be entered with the usual wild card entries (except $)
Default value = 0. The default ID for all Source endpoint is 0 and all
accept #'s is 0. This results in all calls being routed based on the
dialed number.
X
= any digit 0—9
[1,3,5]
= any of these digits