Filter
Top Products
Chapter 5. Using the Terminal Menu
5-18
ATLAS
_ 800
PLUS
User Manual 61200226L1-1
To change the password, follow this procedure:
1. Select the Password field—a new Pa ss w or d field displays.
2. Type the new password in the Enter field.
3. Type the new password again in the Confirm field.
The password can contain up to 12 alphanumeric characters. You can also use
spaces and special characters in the password.
Active
Read security: 5
Displays the number of users for each label that are currently logged into the
system.
SYSTEM UTILITY
Use the System Utility menu to view and set the system parameters shown in Fig-
ure 5-5.
Figure 5-5. System Utility Menu
Update Firmware
Write security: 1; Read security: 5
Updates firmware when ATLAS_ 800
PLUS
enhancements are released. Two trans-
fer methods are available for use in updating any modules that contain flash
memory—including the ATLAS system controller. The first transfer method uses
the ATLAS serial Chain-In port of the system controller and XMODEM protocol.
The second transfer method uses the ATLAS built-in Ethernet port of the system
controller and TFTP (Trivial File Transfer Protocol). For detailed information on
how to update firmware, see “Updating Firmware” on page 8-1.
The available update options change depending on whether you select Slot 0, Slots
1 through 8, or All Modules of a Type.
Module Slot
Write security: 1; Read security: 5
Displays the slot you selected for firmware updating. When this option first
appears, None Selected displays. Press Enter, and a new field displays allow-