Filter
Top Products
Chapter 5. Using the Terminal Menu
5-50
ATLAS
_ 800
PLUS
User Manual 61200226L1-1
.
Quad Nx56/64 Module (User Termination)
When you are working in the User Termination section of the Dial Plan menu, and
the Slot is defined as a QuadNx56/64 module, the following interface configura-
tion options are available:
Ports Available
Indicates which of the four ports of the Quad Nx56/64 module have already been
defined either in another switched end point (indicated by “s”) or in a Dedicated
Map (indicated by “n”). This field is read-only.
Number of Ports
Defines to ATLAS how many of the ports could be used to answer calls to the
number(s) defined in the Accept Call list. You can enter numbers 1 through 4. The
ports are contiguous beginning with the Port number select and the number of
ports.
Example:
If the port selected (as a part of Slot/Port selection) is 2, and the number of
ports selected here was 2, then ports 2 and 3 would be enabled to receive calls
to the numbers listed under the Incoming Call Accept list.
Octal BRI Module Configuration
This section describes the Network Termination and User Termination configuration
settings for Octal BRI module when using the Dial Plan menus.
Octal BRI Module (Network Termination)
The Octal BRI with a “U” interface can interface directly to the Network (PSTN).
When you are working in the Network Termination section of the Dial Plan menu
and the Slot is defined as a UBRI-8 option module, the following interface config-
uration options are available:
Switch Type
Write security: 2; Read security: 5
Defines the type of ISDN switch that ATLAS is connected to. If connected to
another ATLAS, both need to be set to the same type. Choices include the follow-
ing:
• Lucent 5E
• Northern DMS 100
• National ISDN
SPID List
Write security: 2; Read security: 5
In order to properly operate with a network (PSTN) ISDN switch, the BRI inter-
face must have SPID (Service Profile Identifier) and phone number(s) that match
the SPID(s) and Phone number(s) which have been programmed into the ISDN
The Quad Nx56/64 can only serve as a user termination end point