Filter
Top Products
Chapter 5. Configuration Menu
5-12 ESU 120e User Manual 61200420L1-1
Subnet Mask This defines which part of a destination IP address is
the Network number. It is used along with the ESU
120e IP address to determine which nodes must be
reached through the default IP Gateway. This value
is set to 0.0.0.0 when the IP interface option is set to
SLIP.
Default Router All IP Packets destined for nodes not on the ESU
120e unit’s local network are not forwarded through
this IP address. Normally, this address defines a
router connected to the ESU 120e unit’s local
network. This value is ignored when the IP interface
is set to SLIP.
SLIP Rate This sets the baud rate for the Chain-In port when
used as the SLIP connection for SNMP management.
Choices: 1200, 2400, 9600, 19200, 38400
SLIP Flow CTL This is used to activate flow control on the Chain-In
port when used as the SLIP interface. Hardware
mode uses RTS and CTS.
Choices: None, Hardware
Proxy Traps This determines which interface is used for
forwarding traps from units being “proxied” for.
Choices: 10 BaseT, Chain-In
Menu Item Description