Filter
Top Products
Chapter 7. Test Menu
61200420L1-1 ESU 120e User Manual 7-5
PATTERN RESULT
Displays the results of the test currently active. Leaving and
returning to this menu item does not interrupt the test.
Pressing 2 injects errors into the test pattern. These errors are
detected by the device performing the pattern check.
Clear results by pressing shift 9. The results are accumulated until
the test pattern is set to None or Cleared.
Using TST TS0s for testing can be very useful, particularly in Frac-
tional E1 applications. You can run an end-to-end test on the Frac-
tional TS0s by 1) setting for Map B the TST in the same TS0 as used
by Map A to receive data from an Nx56/64 port and 2) by looping
the far end using a V.54 loopback code on the Nx56/64 port. In
addition, a single TS0 can be used for continuous testing while
other TS0s are passing normal data. This will also provide an end
to end check on the entire link. Set each end to send QRSS in TST
TS0s (using 1 TS0) and occasionally view the results on the Pattern
Result menu selection.
ES The number of seconds with at least 1 bit error.
BES The number of seconds with more than 1 bit error and
less than 320.
SES The number of seconds with more than 320 bit errors.
*SYNC Indicates if pattern sync is (yes) or is not (no) valid. The
asterisk (*) indicates if pattern sync has been lost since
the start of testing.