Filter
Top Products
18 MIC-3318 User's Manual
2.1 IDE Device (2F-CN8, CN9)
The MIC-3318 provides one IDE (Integrated Device Electronics)
channel, but supports two secondary IDE devices via two connectors
sepeartely, one is for one on-board 2.5" HDD and the other is for
wiring out to the front panel to connect with external devices.
If two drives are installed on one channel, remember to set one as the
master and the other one as the slave. You may do this by setting the
jumpers on the drives. Refer to the documentation that came with your
drive for more information. A jumper diagram usually appears on the
topside of a hard disk drive.
Warning: Plug the other end of the cable into the drive with pin #1 on
the cable corresponding to pin #1 on the drive. Improper connection
will damage the drive.
2.2 CompactFlash Interface (1F-CN2)
This socket accepts an IDE-compatible CompactFlash memory card.
2.3 VGA Display Connector (1F-CN7)
The MIC-3318 provides an VGA controller for a high performance VGA
interface. The MIC-3318's CN7 on 1F is a DB-15 connector for VGA
monitor input. Pin assignments for the VGA display are detailed in
Appendix B.
2.4 PS/2 Keyboard and Mouse Conn. (1F-CN1)
The MIC-3318 provides a 6-pin mini-DIN connector on the front panel
for connection of PS/2 keyboard and PS/2 mouse. The MIC-3318
comes with an cable to convert from the single 6-pin mini-DIN connec-
tor to a double PS/2 keyboard connector and PS/2 mouse connector.
Since these two connectors are identical, please follow the icons on
the cable to plug the keyboard and the mouse into their correct
connectors.