Filter
Top Products
MIC-3368 Series User Manual -- Page
14
Port Address Default
COM1 3F8, 3E8 3F8/IRQ4
COM2 2F8, 2E8 2F8/IRQ3
2.5 Ethernet Configuration (CN6 and CN7)
The MIC-3368 is equipped with dual high performance 32-bit PCI-bus Fast Ethernet
interfaces which are fully compliant with IEEE 802.3u 10/100Base-TX specifications.
It is supported by all major network operating systems and is 100% Novell NE-2000
compatible. One on-board RJ-45 jacks provide convenient connection to the
network. Another one has to go through RIO module as well as COM port. The
medium type can be configured via the software program included on the utility
CD-ROM disc. (See Chapter 3 for detailed information.).
2.6 USB Connector (CN4)
The MIC-3368 provides one USB (Universal Serial Bus) interface via the rear I/O
module panel. The USB interface gives complete plug and play, hot attach/detach
for up to 127 external devices. The MIC-3368 USB interface complies with USB
specification rev. 1.0 and is fuse protected. The USB interface can be disabled in the
system BIOS setup. The USB controller default is "Enabled" but the USB keyboard
support default is "Disabled".
2.7 PMC Connector (CN4)
The MIC-3368 support two PMC (PMC Mezzanine Card) modules on PCI bus 0. The
MIC-3368 support two PMC (PMC Mezzanine Card) modules on PCI bus 0. This
32-bit, 3.3 V PCI bus is available at connectors J11 and J12. J14 is used for PMC rear
panel I/O per the PMC specification (IEEE P1386.1/Draft 2.2). Front panel access is
provided for the PMC interface. Signals from PMC modules that support rear panel
I/O are routed out the rear of the board through backplane connector J3. A second
PMC position is also available as an option. This position replaces the EIDE drive
capability, front panel video, and Serial Port access. This 32-bit, 3.3 V PCI bus is
available at connectors J21 and J22. J24 is used for PMC rear panel I/O per the PMC
specification (IEEE P1386.1/Draft 2.2). Rear panel I/O from this PMC site is routed
out the rear of the board through backplane connector J5.
2.8 Card Installation
The CompactPCI™ connectors are firm and rigid, and require careful handling while
plugging and unplugging. Improper installation of a card can easily damage the
backplane of the chassis. The inject/eject handles of MIC-3368 help you install and