Filter
Top Products
MIC-3368 Series User Manual -- Page
21
VGA controller has an integrated 4 MB SDRAM operating at 83 MHz, and can drive
CRT displays with resolutions up to 1600 x 1200 @ 64 K colors. It supports
interlaced and non-interlaced analog monitors (color and monochrome VGA) in
high-resolution modes while maintaining complete IBM VGA compatibility. Digital
monitors (i.e. MDA, CGA, and EGA) are NOT supported. Multiple frequency
(multi-sync) monitors are handled as if they were analog monitors.
4.2 Installation of SVGA Driver
The MIC-3368 is supplied with a utility CD-ROM disc that holds the necessary file for
setting up the VGA display under the directory \MIC3368\VGA. The contents and
pathnames of this directory are listed below:
• MIC3368\VGA\Win31: VGA utility for Windows 3.1
• MIC3368\VGA\Win95\w95500: VGA utility for Windows 95
• MIC3368\VGA\Win98\w98600: VGA utility for Windows 98
• MIC3368\VGA\WINNT: Utility for Windows NT 4.0
• MIC3368\VGA\OS2: VGA utility for OS/2
Complete the following steps to install the VGA driver. Follow the procedures in the
flow chart that apply to the operating system you are using with your MIC-3368.
4.3 Installation for Windows NT 4.0
1. Select "Settings" "Control Panel" from the "Start" menu.
2. Click "Display".
3. Select the "Settings" tab and click the "Display Type" button.
4. Click "Change" button in the "Adapter Type" block.
5. Click "Have Disk" button in the "Change Display" Windows.
6. Insert the utility CD-ROM disc in drive E. Type "E:\MIC3368\VGA\WINNT” in the
blank column. Click "OK".
7. Click "OK".
8. Click "OK" to install the VGA driver.
9. Wait for installation to finish.
10. Click "OK" and restart the computer to enable the change to take effect.