Filter
Top Products
The logic analyzer can be configured for USB analysis
by loading the USB configuration file. Loading this file
will load the Universal Serial Bus inverse assembler
and configure your logic analyzer for USB analysis.
Setting up the
Analyzers installed in
the 16500 mainframe.
1. Install the 16500 USB Analysis Probe Software
for the FS4100 flexible diskette in the disk drive
of the logic analyzer.
2. Configure the menu to “Load” the analyzer with
the appropriate configuration file (see table
below).
Logic Analyzer File name
16555, 16710/1/2 USB555
166x USB660
16550 USB550
3. Execute the load operation to load the file into
the target logic analyzer. NOTE: Do not select ALL
or SYSTEM as the target of the load operation,
select the logic analyzer that is connected to the
USB Analysis Probe.
The 16600/16700 requires a special install procedure
to install the FS4100 software. To accomplish this,
insert the diskette labeled 16700/702 Installation
disk for the FS4100 into the 16700/702 diskette
drive. From the SYSTEM ADMINISTRATION TOOLS
select INSTALL under SOFTWARE. From the
SOFTWARE INSTALL screen select the FLEXIBLE
DISK and APPLY. The package FS4100 will now
appear. Select it and then select INSTALL. This
procedure does not need to be repeated. It only
needs to be done the first time the USB Analysis
Probe is used.
Setting up the 167xx
Analyzer
When this has completed restart the logic analysis
session and either invoke the Setup Assistant from
the logic analyzer screen or load the appropriate
configuration file from the
Configs/FuturePlus/FS4100 directory. The Setup
Assistant will guide you in configuring the logic
analyzer. Select FuturePlus from the list on the left of
the Setup Assistant screen and then USB from the list
that then appears. If you prefer to load the
12