Filter
Top Products
configuration file yourself, see table below for a list of
analyzers and corresponding configuration files.
Note: The Logic Analysis System’s Operating System
must be version A.01.40.00 with patches 034 and 035
or higher to be compatible with the software provided
on the installation diskette for the 167xx.
The 1680/90/900 Analyzer is a PC based application
that requires a PC running the Windows OS or a
16900 frame.
Setting up the
1680/90/900 Analyzer
Before installing the protocol decoder for the USB
protocol on a PC you must install the Agilent logic
analyzer software. Once the Agilent logic analyzer
software is installed, you can install the FS4100
protocol decoder by placing the CD-ROM disk into the
CD-ROM drive of the target computer or Analyzer and
executing the .exe setup program that is contained on
the disk. The .exe setup file can be executed from
within the File Explorer PC Utility. You must navigate
to the .exe file on the CD-ROM disk and then double
click the .exe file name from within the File Explorer
navigation panel.
The installation procedure does not need to be
repeated. It only needs to be done the first time
the Analysis Probe Adapter is used.
The USB Inverse Assembler is a licensed product that
is locked to a single hard drive. The licensing process
is performed by Agilent. There are instructions on this
process on the SW Entitlement certificate provided
with this product.
1680/90/900 licensing
Loading 1680/90/900
configuration files
When the software has been licensed you should be
ready to load a configuration file. You can access the
configuration files by clicking on the folder that was
placed on the desktop. When you click on the folder it
should open up to display all the configuration files to
choose from. If you put your mouse cursor on the
name of the file a description will appear telling you
what the setup consists of, once you choose the
configuration file that is appropriate for your
configuration the 16900 operating system should
execute. The protocol decoder automatically loads
when the configuration file is loaded. If the decoder
does not load, you may load it by selecting tools from
13