Filter
Top Products
Standard Device Requests
GET_CONFIGURATION
SET_CONFIGURATION
GET_INTERFACE
SET_INTERFACE
SYNCH_FRAME
COMBINATION
MODE
The default mode set up by the software shipped with
the Analysis Probe is the following configuration.
Bad EOP Detection
If the FS4100 operating in full speed mode, detects a
valid SE0 for at least 60ns but a valid J_STATE does
not follow, it will do the following.
1. Detect an end of packet (FEOPR TRUE in Timing
mode).
2. Pass the packet up to the logic analyzer.
3. Pass a “ POSSIBLE BAD EOP” status to the
analyzer.
If the FS4100 operating in slow speed mode, detects
a valid SE0 for at least 300ns but a valid J_STATE
does not follow, it will do the following.
1. Detect an end of packet (FEOPR TRUE in Timing
mode).
2. Pass the packet up to the logic analyzer.
22