Filter
Top Products
the menu bar at the top of the screen and select the
decoder from the list.
After loading the configuration file of choice, go into
the format specification of the configuration by
choosing Setup from the menu bar and then selecting
Bus/Signal in the drop down menu. When the format
specification appears press Define Probes at the
bottom of the screen. The Define Probes feature will
describe how to hook the analyzer cards to the
connections on the target. The following figure shows
what the Define Probes screen looks like. The figure
below may differ from your display; this is an example
of how the display looks in general.
Note: In the above picture under Logic analyzer pods, the first
pod goes to the Odd pod and the second goes to the Even pod
of the termination adapter (e.g. Pod B1 goes to odd termination
adapter pod and B2 goes to the even termination adapter pod).
14