Filter
Top Products
Back Up Power Supply OmniSwitch 6600 Series Chassis and Hardware Components
page 2-18 OmniSwitch 6600 Series Hardware Users Guide April 2004
Back Up Power Supply
OmniSwitch 6600 series switches provide one factory-installed power supply per chassis. Each switch also
provides one bay for the optional OS66BPS-100A back up power supply. The back up power supply bay
is located on the chassis rear panel (see page 2-12 for details).
For information on installing a back up power supply, refer to page 2-20. For information on removing a
back up power supply, refer to page 2-22.
Back Up Power Supply Front Panel
Power Supply Redundancy
After a back up power supply is installed, the primary (factory-installed) power supply continues to take
on the full power load for switch operations. Meanwhile, the back up power supply operates in active
standby mode. If the primary power supply fails unexpectedly, the back up power supply automatically
takes up the full power load without disrupting the switch.
Back Up Power Supply Specifications
Input Voltage 85 to 250 VAC
Input Frequency 47 to 63 Hz
Efficiency 75% measured at 115 VAC
Temperature Operating: 0 to +50 Celsius
Non-Operating: - 40 to +85 Celsius
Relative Humidity 5% to 95% non -condensing
Altitude 10,000 feet @ +32 Celsius
!
CAUTION:
THIS UNIT MAY BE EQUIPPED
WITH TWO POWER CONNECTIONS. TO REDUCE
THE RISK OF ELECTRICAL SHOCK, DISCONNECT
BOTH POWER CONNECTIONS BEFORE
SERVICING UNIT.
ATTENTION:
CET APPAREIL COMPORTE
PLUS D'UN CORDON D'ALIMENTATION. AFIN DE
PREVENIR LES CHOCS ELECTRIQUES, DEBRANCHE
LES DEUX CORDONS D'ALIMENTATION AVANTE DE
FAIRE LA REPARATION.
50/60 Hz, 2/2/1 A
100/115/230 V
Power Switch.
indicates on position;
indicates off position.
Power Connector Socket.
Type IEC-320-C13. Supports
one 10 amp power cord.
It is recommended that you use
Alcatel-provided power cords.
Product, Safety, and Compliance Information.
Refer to the “Regulatory Compliance and Safety
Information” chapter for detailed information.