Filter
Top Products
System Requirements
page 4 OmniSwitch 6800/6850/9000—Release 6.1.3.R01
System Requirements
Memory Requirements
• OmniSwitch 6800 Series Release 6.1.3.R01 requires 256 MB of SDRAM and 64MB of flash memory.
This is the standard configuration shipped.
• OmniSwitch 6850 Series Release 6.1.3.R01 requires 256 MB of SDRAM and 64MB of flash memory.
This is the standard configuration shipped.
• OmniSwitch 9000 Series Release 6.1.3.R01 requires 256 MB of SDRAM and 128MB of flash
memory. This is the standard configuration shipped.
Configuration files and the compressed software images—including web management software
(WebView) images—are stored in the flash memory. Use the show hardware info command to deter-
mine your SDRAM and flash memory.
UBoot, FPGA, Miniboot, BootROM, and Upgrade Requirements
Note. Field upgrade of existing OmniSwitch units is required prior to loading this release. See the Upgrad-
ing OmniSwitch 6800, 6850, and 9000 Series Switches to 6.1.3.R01 upgrade instructions for more informa-
tion.
The software versions listed in this section are the minimum required, except where otherwise noted.
OmniSwitch 6800 Series
• Miniboot: 6.1.2.49.R03 or later
• BootROM: 6.1.2.49.R03 or later
OmniSwitch 6850 Series
• UBoot: 6.1.3.601.R01 or later
• Miniboot.uboot: 6.1.3.601.R01 or later
OmniSwitch 9000 Series
• UBoot NI: 6.1.1.167.R02 or later
• UBoot CMM: 6.1.1.167.R02 or later
• Miniboot.uboot CMM: 6.1.1.167.R02 or later
• FPGA CMM: Major Revision: 2 Minor Revision: 25 (displays as 0x19)
POE Firmware
• 5.01